Advanced configuration

Add output configurations for each value

Use the output tab to create one output configuration for each value to display on the LCD. For example, create rows for the COM1 and COM2 active and standby frequencies.

Each output should have the Sim Variable tab configured for the desired value. The Display tab should be left blank.

Create an LCD output configuration

Add an output configuration for the LCD with a description of the output, for example Radio value display. Click the button with three dots in the Edit column for the row to edit the configuration.

Add config references to an LCD output configuration

Add a new output configuration for the LCD, but do not select a variable on the Sim Variable tab. Instead, click the Add Reference button on the Modify tab.

A new reference to an existing output configuration will be added. If the selected reference is not one of the radio values configured in the previous step use the dropdown to select the correct output.

Add the remaining references

Repeat the previous step three more times to add config references to the remaining three radio values.

Select the board and device type for the output

On the Display tab, use the Module and Use type of dropdowns to select your connected board and the LcdDisplay device type.

Select the device

Use the Display dropdown to select the specific display to use.

Format the display output

Replace the Text section sample text with the values to show on the display. Use the placeholder symbols from step four to indicate where the digits should be placed, and include a decimal at the appropriate location.

Close the dialog and try it out

Click the OK button to close the dialog, then spawn an airplane in Microsoft Flight Simulator.

Make sure the MobiFlight Run button is clicked in the toolbar, then verify the display shows the four frequencies.